EH60
The EH60 is a full featured Engine Hours and Elapsed Trip Time gauge which displays total engine hours
and elapsed trip time from 000.0 hours to 9999 hours. A built-in engine hours countdown alarm can be set to warn you to
perform needed maintenance such as changing the engine oil or oil filters. When activated the built-in alarm will sound
and the display will flash.
The total engine hours can be preset for retrofit to older existing engines.
Five levels of backlighting can be selected from the front panel, including OFF and the backlights can be deactivated
with a remote switch. All calibration and alarm values are saved to a nonvolatile memory. The EH60 is easy to install
with a minimum of only two wires connected to the ignition line and ground.
All constants and calibrations are pre-set during manufacture but you may alter these settings to suit
your particular needs. All calibrations and settings are saved to a non-volatile memory that works without power
for ten years.
With a press of the button you can display either Total Engine Hours or Elapsed Trip Time.
An engine maintenance alarm can be set using the front panel switches and it will remind you when its
time to change the oil, check water levels, etc..
The EH60 draws only 0.018 amps and 5 levels of backlight (including OFF) can be selected from the
front panel and is saved to non-volatile memory.
The EH60 outputs Total Engine Hours, and Elapsed Time on the standard NMEA 0183 serial data line at
4800 BAUD. This ASCII information can be used to log performance or repeat the display information at a remote location
on the CruzPro RP60 and/or RP110 data repeaters (see www.cruzpro.com/rp60.html, www.cruzpro.com/rp110.html and www.cruzpro.com/maxrp110.html).
