Download User's Manual PDF
Digital Pyrometer Gauge
Waterproof front case
- Operating Voltage:
- 9.5 - 33.0 VDC
- Current Drain:
- 0.018 amps nominal
- 4 digit LCD, 5 levels of backlighting
- Temperature 32 to 2000 degrees F
- (0 to 1100 deg C) +/- 1%
- Maximum Temperature seen memory
- Thermocouple (type K provided)
- Data Ouput:
- NMEA 0183 serial 4800 BAUD
- Built-in 85 dB audible alarm. Settable high and low temperature alarms
- 2.5" dia X 4.1" deep (61mm x 104mm)
- 2-1/8" (55mm) round hole
PY60 The PY60 pyrometer displays engine exhaust gas temperature in degrees F or C. It comes
with an 1100 deg C type K thermocouple. Low and High temperature alarms can be set over the entire
range of the instrument. When activated, the PY60 built-in 85 dB alarm will sound and the display will
flash. The alarms can be enabled or disabled with a single key press. Five levels of backlighting can
be selected and all set-up, calibrations constants, alarm values and Max. temperature seen is saved to
non-volatile memory. Data is output on an NMEA 0183 compatible serial data output.
All constants and calibrations are pre-set during manufacture but you may alter these settings
to suit your particular needs. Calibrations can be altered over a wide range using the front-panel
switches. All information is automatically saved to non-volatile memory.
With a press of the button you can display exhaust gas temperature (in deg F or C), High and Low
temperature alarm set-points, and Maximum temperature seen (since last reset).
The PY60 draws only 0.017 amps and 5 levels of backlight (including OFF) can be selected from the
front panel and is saved to non-volatile memory.
The PY60 outputs temperature on the standard NMEA 0183 serial data line at 4800 BAUD.
This ASCII information can be used to log performance or repeat the display information at a remote location
on the CruzPro RP60, RP110 and/or MaxRp110 data repeaters (see www.cruzpro.com/rp60.html, www.cruzpro.com/rp110.html) and
If NMEA 0183 serial data
is not required, then the output terminal can be programmed as an external alarm output pin.
PY60 Connection Diagram "A" Version and "B" Version
Connecting the CruzPro ER-1 External Relay module to the NMEA 0183/External Alarm Output
Click here to go to ER-1 page
The stock thermocouple shipped with the PY60 is K-type stainless
steel with a compression gland and isulated tip. The part number for replacement thermocouples is TH-3
The maximum tip temperature is 1100 deg C (2000 deg F).
Any isolated K-type or J-type thermocouple can be used with the PY60. Be sure to
use an isolated thermocouple (the two wires coming from the thermocouple are electrically
isolated from the metal thermocouple body).
The wires exiting the thermocouple pot end are 80 inches (200 CM)long. You will need
an extension cable between the thermocouple and the PY60 display head. The electrical
connections created by connecting the extension cable wires to the thermocouple wires will each
create a new "thermocouple junction". If you use K-type thermcocouple extension leads then
the voltage created by the two new junctions will cancel (if wired correctly) and have no effect
on the displayed temperature readings. If the temperature variations of the additional
thermocouple junctions are not excessive you might be able to use standard copper wire for the